Mytee S-300 TEMPO User's Guide download pdf (Page 7)

MODEL DESCRIPTION/ OPERATION

S-300/ Tempo™

The Tempo™ spot extractor is equipped with a 55-psi pump and a two stage vacuum motor.

The solution and recovery tanks are 1 1/2 gallons.It is a single cord unit. The power cord is 12/3

25', and it draws about 9-amps (115v). To run effectively, use a dedicated 15-amp outlet.

NOTE: All units come with an 8

' vacuum and solution hose assembly with 3'' S/S upholstery

tool.

OPERATION:

1. Plug in yellow electrical cord into a dedicated 15-amp circuit outlet

2. Fill solution tank with water, and add 1/2 cup of rinse additive. DO NOT OVERFILL!!

3. Attach vacuum and solution hoses to appropriate connections on the machine and

your wand. Make sure the quick disconnects snap together firmly. As you do this,

always inspect hoses for cracks or fraying. Do not use if hoses are damaged.

4. Turn power switch ON, and press trigger on wand until there is a continuous flow of

water. Your pump is now primed.

5. With the wand you may begin cleaning. By pulling the trigger, you will dispense the

solution onto the desired area. Because the vacuum is on, the fluid will quickly be

sucked back into the wand. You will notice that the area you have just cleaned will be

damp. This is normal. To speed up the drying process, use the model 2500 Windstar or

2200 Windstorm airmover.

1 2 3 4 5 6 7 8 9 10 11

No comments

Mytee S-300 TEMPO User's Guide Page 7