4
RECOVERY TANK DRAIN
Located at the rear of the Mytee-Lite™ is a bucket high
drain valve. Simply unscrew the tethered cap to release
the recovery water.
VACUUM STACK FILTER
The Mytee-Lite’s™ internal lter must be cleaned regu-
larly and is located in the recovery tank. Twist the lter
to remove then clean and replace. If the lter is torn or
damaged, replace with a new one.
VACUUM SWITCH
Turn on vacuum motor and begin cleaning. For best
results make two dry passes for every wet pass.
HEATER SWITCH
Release tool trigger. Turn on heater. Wait 8 – 10 minutes
for unit to pre-heat. Once heated, re-key upholstery tool
until hot water begins owing. Once hot water is owing,
release trigger and pre-heat an additional 4 – 5 minutes.
8070 MYTEE-LITE™
Comments to this Manuals